Edelbrock Automobile Parts R09430 User Manual

Front Brake Hose Kit  
for 2004-2006 Yamaha Rhino  
Catalog #R09430, #R09431  
INSTALLATION INSTRUCTIONS  
Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call  
our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or  
e-mail us at [email protected]. Please fill out and mail your warranty card.  
IMPORTANT NOTE:  
Proper installation is the responsibility of the installer. Improper installation will void warranty and may  
result in poor performance and engine or vehicle damage.  
INSTALLATION INSTRUCTIONS  
IMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.  
Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).  
1. Remove factory brake hoses, noting routing. NOTE: Factory cable tie-style hose retainers are re-usable - pull tab  
on locking end of tie away from strap to release (See Fig. 1).  
2. Route Russell upper hose similar to factory. Mount T-block end onto chassis in factory location. (NOTE: Do not  
install banjo onto master cylinder until lower hoses are installed). Insert supplied bushing into T-block so that  
flange is between mounting surface and T-block (See Fig. 2).  
Fig. 1  
Fig. 2  
Catalog #R09430, #R09431  
Brochure #63-0490  
Page 1 of 2  
©2006 Edelbrock Corporation  
Rev. 3/06 - BC/mc  
 

EdgeStar Beverage Dispenser 866 319 5473 User Manual
Fender Guitar G 5 User Manual
FujiFilm Digital Camera 16395586 User Manual
Fujitsu Laptop N6220 User Manual
Fujitsu Printer FTP 628MCL101 User Manual
FUNAI CRT Television IWF2706 User Manual
Garmin GPS Receiver Venture Cx Legend Cx User Manual
Gateway Computer Monitor XHD3000 User Manual
GE Clothes Dryer PSXH47 User Manual
GE Kitchen Utensil 106612 User Manual