Edelbrock Automobile Parts R09392S User Manual

Catalog #R09392S  
Russell DOT Rear Brake Hose Kit  
for 2006 Honda CBR1000RR  
INSTALLATION INSTRUCTIONS  
Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call  
our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard Time or e-mail us  
IMPORTANT NOTE:  
Proper installation is the responsibility of the installer. Improper installation will void warranty and may  
result in poor performance and engine or vehicle damage.  
INSTALLATION PROCEDURE  
IIMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.  
Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).  
1.  
2.  
3.  
4.  
5.  
6.  
Remove factory rear brake hose, noting routing.  
Install bent banjo hose end onto master cylinder so hose loops upward, similar to factory.  
Install straight hose end onto caliper oriented approximately 30° inward (See Fig. 1).  
Use supplied cushion clamp to secure hose at factory location on swingarm.  
Check hose clearance throughout entire suspension travel range.  
Bleed system and check for leaks while applying pressure.  
Fig 1  
Edelbrock Corporation, 2700 California St., Torrance, CA 90503  
Tech Line: 800-416-8628  
Office: 310-781-2222  
Catalog #R09392S  
Rev. 7/06 - BC/mc  
©2006 Edelbrock Corporation  
Brochure No. 63-R09392S  
 

Eizo Computer Monitor L568 L568 AS User Manual
Electro Voice Portable Speaker MC12 User Manual
Ericsson Network Router W3X User Manual
Fagor America Electric Pressure Cooker SZ2L00002 User Manual
Fostex DVR D2424LVMKII User Manual
Fujitsu Air Conditioner AOU12RLS User Manual
Fujitsu Air Conditioner AOU18CXQ User Manual
Fujitsu Marine Sanitation System C300 User Manual
GE Toaster 169045 User Manual
Global Machinery Company Drill LD108V User Manual