Edelbrock Automobile Parts Chrysler Big Block V8 User Manual

BIG BLOCK CHRYSLER VALLEY COVER PLATES  
For B and RB Chrysler Engine Blocks  
Catalog #7798 & 7799  
®
INSTALLATION INSTRUCTIONS  
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with  
common tools and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do  
not feel comfortable performing this installation, it is recommended to have the installation completed by a qualified  
mechanic. If you have any questions, please call our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific  
Standard Time, Monday through Friday or e-mail us at [email protected].  
IMPORTANT NOTE: Proper installation is the responsibility of the installer.  
Improper installation may result in poor performance and engine or vehicle damage.  
DESCRIPTION: These steel Valley Cover Plates are designed to cover the lifter valley of Chrysler big block V8 engines  
when Edelbrock Victor Big Block Chrysler cylinder heads #77919 or 77929 are used. A stock sheet-metal valley cover  
may not be used with Edelbrock Victor cylinder heads. Part #7798 fits Chyrsler RB (413-426 Wedge-440) engine blocks  
and #7799 fits Chrysler B (361-383-400) engines.  
KIT CONTENTS:  
1 Valley Cover Plate  
14 1/4-20 x 1/2” bolts  
INSTALLATION PROCEDURE  
(NOTE: Install the valley cover only AFTER your Edelbrock cylinder heads have been installed.)  
1. Be sure that the mating surfaces of the block and the surface of the cylinder heads that will meet the valley  
cover are thoroughly clean and free of any oils or debris before installation. Use alcohol or lacquer thinner  
on a lint-free rag to clean.  
2. Apply a continuous, 1/8” bead of automotive RTV silicone sealer to the end sealing surfaces on block and  
along bottom of intake flange on the cylinder head where it will meet the valley cover.  
3. Pay special attention to the corners of the cylinder heads where they meet the end seal surfaces (Use a  
bit more silicone here).  
4. Position the valley cover in place on the engine and install the supplied bolts.  
5. Tighten bolts to 10-12 ft./lbs., starting in the center and working your way to the ends.  
6. Place the intake manifold in position and torque manifold bolts to 25 ft. lbs., following the factory torque  
sequence.  
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503  
Tech Line: 1-800-416-8628  
Catalog #7798, 7799  
Rev. 12/07 - AJ/mc  
©2007 Edelbrock Corporation  
Brochure #63-0487  
 

ETA Systems Surge Protector ETA S20 User Manual
Euro Pro Vacuum Cleaner NV31 User Manual
Eurotech Appliances Computer Hardware FM12961 User Manual
Excalibur electronic Games EI AB04 User Manual
Fisher Paykel Refrigerator RS90A1 User Manual
Fisher Price Baby Toy C4503 User Manual
Frigidaire Dehumidifier D25D User Manual
GE Air Conditioner AGF06 User Manual
Gefen Marine Radio EXT DVI 1CAT5 ELR User Manual
GE Network Router A8950CC User Manual