Edelbrock Automobile Parts R09430 User Manual

Front Brake Hose Kit  
for 2004-2006 Yamaha Rhino  
Catalog #R09430, #R09431  
INSTALLATION INSTRUCTIONS  
Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call  
our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or  
e-mail us at [email protected]. Please fill out and mail your warranty card.  
IMPORTANT NOTE:  
Proper installation is the responsibility of the installer. Improper installation will void warranty and may  
result in poor performance and engine or vehicle damage.  
INSTALLATION INSTRUCTIONS  
IMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.  
Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).  
1. Remove factory brake hoses, noting routing. NOTE: Factory cable tie-style hose retainers are re-usable - pull tab  
on locking end of tie away from strap to release (See Fig. 1).  
2. Route Russell upper hose similar to factory. Mount T-block end onto chassis in factory location. (NOTE: Do not  
install banjo onto master cylinder until lower hoses are installed). Insert supplied bushing into T-block so that  
flange is between mounting surface and T-block (See Fig. 2).  
Fig. 1  
Fig. 2  
Catalog #R09430, #R09431  
Brochure #63-0490  
Page 1 of 2  
©2006 Edelbrock Corporation  
Rev. 3/06 - BC/mc  
 

Conair Car Seat BM1RL User Manual
Cooper Lighting Landscape Lighting PSL User Manual
Coustic Car Amplifier AMP 801DB User Manual
Craftsman Garage Door Opener 13918451D User Manual
Craftsman Lawn Mower 917270751 User Manual
Cuisinart Mixer HSM 70 User Manual
Cuisinart Oven TOB 155 User Manual
Desa Oven MSRBVN User Manual
EVGA Computer Hardware 121 LF E652 User Manual
Extron electronic Stereo Receiver HDMI 201 Rx User Manual